Back
Back
Back

Whirlpool Baths

Whirlpool Baths

  • Please be sure that all jets and intakes are covered by at least two inches of water before operation. Please be sure that the air intake control (usually the scalloped wheel on the top edge of the tub) is open (so that air can enter the system) before use. The whirlpool will not work fully if the intake is closed.

Air Tubs

  • To regulate the flow/strength on air tubs, the dial is located on the ledge of the tub with buttons to increase or decrease the jet speed. After draining the tub, an automatic drying cycle will start 20 minutes later and this will take about 1 minute to empty the lines.

Jet Tubs

  • To regulate the flow/strength on jet tubs, adjust by turning the individual jets, which increases or decreases the jet speed.